Mould Clamps
MR Mould Clamp
| The MR CLAMP is a rotational mould clamp fabricated from mild steel with a zinc finish.
The MR Clamp has been designed for attachment to rotational mould flanges of angle type or rectangular bar type of 8mm to 13mm thickness which have been fabricated from steel or cast aluminium.
The unique design of the MR Clamp offers a number of advantages over swan neck rotational mould clamps.
- Robust, rustproof construction - minimises maintenance and replace costs.
- Superior ergonomic design - increased space between handle and mould for easier operation.
- Centreline of clamp - reduces potential mould force nearer the mould flash.
- Simple - quick easy adjustment via single threaded stud.
|
The MR Clamp is available in a range of sizes to suit individual mould holding pressure requirements.
To determine the correct size of MR Clamp for any given application refer to the dimensions table below.
STANDARD DIMENSIONS TABLE
TYPE |
PITCH |
a |
b |
c |
d |
e |
WGT. |
HOLDING
PRESSURE |
|
mm |
mm |
mm |
mm |
mm |
mm |
gm |
Kg |
MR 6 |
250 |
38 |
32 |
60 |
30 |
95 |
510 |
280 |
MR 7 |
300 |
57 |
40 |
88 |
80 |
137 |
950 |
450 |
|
|
|
|
|
|
|
|
|
|
|
 |
Correctly spacing the MR Clamps along the mould flange is important if maximum clamping force using the minimum number of clamps is to be achieved.
The correct spacing can be determined by referring to the pitch measurement for the appropriate clamp using the dimensions table above.
This is the maximum recommended distance between clamps.
SPARE PARTS
Spare parts are available for all MR Clamp sizes.
When ordering spare part refer to the following diagram
to correctly identify the part required.
 |
- Locknut(s)
- Pressure plate
- Heel block
- Stop pin
- Hinge pin
- Handle Clevis pin
- Handle
- Clamp frame
- Bolt
|
FURTHER INFORMATION
For further information on the MR Mould Clamp Contact: - Rotomech Engineering Limited |